Print Page - How to call SINGLE SOUNDS 7-9 to 8-20 via Program Change (and Bank Select)?

Title: How to call SINGLE SOUNDS 7-9 to 8-20 via Program Change (and Bank Select)?
Post by: falconi on December 13, 2020, 09:19:13 PM

OR:
How can I make The River send Program Change-commands? Then I might be able to find out by myself in MIDI-OX or in Cubase...
(I am using the standard MIDI/DIN-connectors, not USB, which should actually be irrelevant...).

Thank you for your advice.

Title: Re: How to call SINGLE SOUNDS 7-9 to 8-20 via Program Change (and Bank Select)?
Post by: Baloran on December 21, 2020, 12:15:51 AM

The RIver does not send a program change when you select a program. This is not expected, you can just manually send programs change with The Riverkey commands.

Title: Re: How to call SINGLE SOUNDS 7-9 to 8-20 via Program Change (and Bank Select)?
Post by: falconi on December 26, 2020, 07:54:14 PM

Dear Laurent,
thank you.

From the manual:
"Program Change and Bank Select midi messages are supported. Banks 32 and 33 ( CC00 = 0, CC32 = 32 or 33)
correspond to the two Multi banks. See the reference document available on forum.baloran.com"

Could you please describe in very detail how to load e.g MULTI 5 in MULTI BANK 2?

Please note the pictures attached. CC0 and CC32 seem to do nothing.
The Program Change command in picture 3.jpg is calling SINGLE 1-1 (Program Change = 1) .
The Program Change command in picture 4.jpg is calling SINGLE 7-8 (Program Change = 128).

How should the MIDI-command really look like?

Baloran Forum

The River => Discussion (English preferably) => Topic started by: falconi on December 13, 2020, 09:19:13 PM