Messages

Hello,
I have updated to 2.12, and all my 4 encoders seem to be working more accurate now, which is great.
However, confirming values by pressing them still sucks - a bit.
What I have just found out: The Problem is NOT the encoder or the applied pressure (like on Roland keyboards from the 90s). It is TIME. I just have to press longer and it works w/o any violence.

How frequently does the DUE-board read out the condition of the encoders? Could you possibly read out/ "mux" with a higher frequency?

Thank you!

[Joyeux Noël!]

Hello,

I have properly set up my MIDI In and Out.
I have created a profile called falconi.
How to send it to the River?
How to call back Profiles from the Instrument?
(I think, I don't want to modify Reverkey configs...and send Config sysex-files, as far as I understand them.)

If both is not the purpose of the Profile Manager: Could you please explain what to do with it?

Joyeux Noël!

Dear Laurent,
thank you.

From the manual:
"Program Change and Bank Select midi messages are supported. Banks 32 and 33 ( CC00 = 0, CC32 = 32 or 33)
correspond to the two Multi banks. See the reference document available on forum.baloran.com"

Could you please describe in very detail how to load e.g MULTI 5 in MULTI BANK 2?

Please note the pictures attached. CC0 and CC32 seem to do nothing.
The Program Change command in picture 3.jpg is calling SINGLE 1-1 (Program Change = 1) .
The Program Change command in picture 4.jpg is calling SINGLE 7-8 (Program Change = 128).

How should the MIDI-command really look like?

OR:
How can I make The River send Program Change-commands? Then I might be able to find out by myself in MIDI-OX or in Cubase...
(I am using the standard MIDI/DIN-connectors, not USB, which should actually be irrelevant...).

Thank you for your advice.