Messages

Appreciate the information !   Could you please tell us if certain boards are more effected by solder joints needing reflowing than others ?  If so that may help someone in the future.

Hi, I've not opened up The River yet to do this, but I will.  Appearantly the VCA pots are marked:   https://gearspace.com/board/electronic-music-instruments-and-electronic-music-production/1136256-baloran-river-synthesizer-166.html#post16246342   Please post the results here if you go for it.

I've done some more checking.  I've just started to explore patch making on the River, that is how I discovered this. All patches seems to have the same level set for each voice, one patch may have all voices set to 0 and another voice may have all set to -10.
As I listen more closely there are 2 voices that are too high - voice 2 and 7. When I lower these two with -2 it is fine. I've tested for several included patches incl INIT and also my own patches. I believe this is caused by inproper adjustment of level on the 2 voice cards. I do not believe other Rivers have the same issue with voice 2 and 7, but maybe other voices - if so this may not be fixed by firmware but maybe by adjusting potmeter in the voice card ?

One of my voices is louder than the others. (when I repeatedly press the same key every 8 note is higher in volume).
Is it just to open up the River and inside there will be 8 adjustment pots for volume - and are they marked ?
Is there an overview somewhere of all adjustment pots inside the River ?