With aftertouch attack/release, I didn't mean the attack/release of VCA or VCF, but the attack/release of the applied aftertouch value - so it won't be applied and released roughly when I apply the aftertouch and when I release it (but still keep the key pressed), but rather smoothly.
- Welcome to Baloran Forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Discussion (English preferably) / Re: Your wishes ;)
November 25, 2021, 08:00:52 PM
Idea for a small improvement - Fine tune knob is very sensitive and sometimes it is difficult to set it to 0, it would be nice to reduce sensitivity around 0 (or keep 0 value for some time while turning the knob).
#3
Discussion (English preferably) / Re: Your wishes ;)
June 27, 2021, 10:47:55 AM
Hello Laurent,
One bug found - when I load a multi-template using Unison with 2 voices, by default it uses all 8 voices, I have to click Unison button 2 times (off/on), then it is OK. This should be easy to fix.
One wish - configurable aftertouch attack/release time - even with soft aftertouch curve it is sometimes too steep, especially release is difficult to control, and it shouldn't be difficult to implement it (could be on S+Velocity and S+Aftertouch).
One bug found - when I load a multi-template using Unison with 2 voices, by default it uses all 8 voices, I have to click Unison button 2 times (off/on), then it is OK. This should be easy to fix.
One wish - configurable aftertouch attack/release time - even with soft aftertouch curve it is sometimes too steep, especially release is difficult to control, and it shouldn't be difficult to implement it (could be on S+Velocity and S+Aftertouch).
Pages1