Messages

The pitch wheel on my River synt, even after calibration (calibration (S-Key -> C8), doesn't always work properly.  Yesterday after several calibrations it began to work properly.  Today, upon power up, it began not working again so I calibrated and it jumps through numbers quickly while bring the pitch wheel to its extreme points.  After several calibrations, it works pitching down, but does not pitch up. Any idea how to alleviate this abnormality?  The Mod Wheel, Aftertouch, and pedal seem to calibrate properly.

When step sequencing, holding a note (or chord) down while pressing the encoder 1 or more times does not hold the note (tie).  The note is just re-triggered that number of times when playing the sequence after entering the steps.  Pressing the encoder while not holding down a note adds that "blank" step (rest).  Please explain how to add ties to notes and chords when entering a sequence step by step.

Also, please let me know how to assign my layers so the recorded sequence is played back not only via MIDI (Layer 4) but also by the internal River patch (Layer 1).  Merci!

I'm unable to access the "Temperaments/Microtonal" menu under S + options.  The menu stops at Polyphonic Aftertouch.  Can someone direct me to where I can find that option?

Also, I have noticed on some patches each voice has different microtonal tuning (unrelated to the TRANS page).  How is this accomplished without me being able to access the microtonal menu?

I've got one oscillator being controlled by the gate and 1v per octave setting.  How do I set up polyphonic cv control for more than one oscillator?

I'm wanting to use the CV outputs of The River to control a eurorack oscillator.  I've successfully got the gate triggering and the output of the oscillator 'sounding', but I'm not getting the 1v per octave assigned for the River's keys to change the frequency (pitch).  Where can I find that option?

The pitch wheel on my River synt, even after calibration (calibration (S-Key -> C8), doesn't always work properly.  Yesterday after several calibrations it began to work properly.  Today, upon power up, it began not working again so I calibrated and it jumps through numbers quickly while bring the pitch wheel to its extreme points.  After several calibrations, it works pitching down, but does not pitch up. Any idea how to alleviate this abnormality?  The Mod Wheel, Aftertouch, and pedal seem to calibrate properly.

I am fortunate to have acquired a River synth in the United States last month.  Digging and discovering more about it every day.  Under the River Key Global Setup it states the synth is running v.2.19.  Is that the latest firmware for the instrument?